Committed to a PCB

So here is the unipolar stepper motor controller committed to a PCB. It’s my first PCB that I’ve made and populated from scratch. I used the toner-transfer method and then drilled out the holes with a small drill. I’ve got a programmer on there so I can upgrade the firmware if needed. The connector for power and a serial command is a bit of a hassle at the moment but will fit in with my grand scheme! Note: this need regulated power, which I’m assuming will come from a master board (the supplier of the serial). This makes sense as I’ll have multiple (modular) controller boards.Unipolar stepper motor controller PCB

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: